5. ROUTES
5-15
5.10.3 How to start navigation from a route point
1. Tap the route point of the route from where to start navigation. The pop-up menu
appears; tap [Start Nav] on the pop-up menu.
2. Tap [Start Nav].
In the example figure below, route point “3” was tapped.
After tapping a route point, the following occurs:
• The route point "3" is selected to start navigation from, and is highlighted. Route
points other than No. 3 are connected with a purple line. The arrows on the route
point in the direction of route flow.
• The line between route points 1 and 2 and 2 and 3 are greyed out.
• A solid purple line with arrows connects between current position and the points on
the route. This line indicates the set course. A solid yellow line runs between runs
between current position and the destination. This line shows the shortest distance
to the destination.
• The arrival area marker appears if activated on the menu (see section 5.11.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines and set their width with [Display XTE Lines] and [XTE Value] re-
spectively in [Routes] menu.
Note 1: If you want to be notified when you reach a Goto point, turn on [Waypoint
Crossing Notification] in the [Routes] menu (see subsection 5.11.8). Then the mes-
sage "Waypoint Crossing" appears when you reach a Goto point. For the arrival tim-
ing, see section 5.11.5.
Note 2: You can also start navigating a route from any location on a route leg. Tap
anywhere on a route leg to show the pop-up menu, then tap [Start from Here] to have
that location become the destination.
To Next Page
Loading...
