12. INSTRUMENT-RELATED DISPLAYS
12-15
12.3.7 How to add an instrument display
Ten full size and six split screen instrument displays are preset in this equipment. If
the displays do not meet your requirements, you may add custom displays as neces-
sary. A maximum of ten each of full screen and split screen displays is available.
1. Tap the instrument display to show the [Choice of Config Type] pop-up menu.
2. Tap [Add Page] to show the software keyboard.
Note: If you have reached the capacity for the screen configuration selected, [Add
Page] is grayed out. Remove an unnecessary page referring to section 12.3.3.
3. Enter a name for the page then tap []. A blank page appears.
4. Tap the blank page to show the [Add Instrument] pop-up menu.
5. Tap a size in the applicable section
6. Repeat steps 4 - 5 to add other items.
7. After you have added all items required, tap the screen to show the [Add Instru-
ment] pop-up menu, then tap [End Edit] to finish.
The page name appears in the [Choice of The Config Type] pop-up menu.
8. if you need to rearrange the data, see section 12.3.2 and section 12.3.3.
The page name appears in the [Choice of The Config Type] pop-up menu.
12.3.8 SC-33/SCX-20 3-axis speed display
With connection of a SC-33/SCX-20 Satellite Compass
™
in the network, a dedicated
3-axis speed display data box can be shown in the data area.
This function requires input of the PGN data sentence 130578 (Vessel Speed Com-
ponents).
Referring to section 12.3.3 and section 12.3.4, tap [3-Axis Speed].
1.23
15.67
1.23
Wind direction
(
purple arrow
)
Tidal current direction
(
brown arrow
)
Port/starboard directional speed
: Starboard
: Port
: Fore
: Aft
Fore/aft directional speed
Speed at stern
Speed at mid-ship
Speed at
CCRP*
Speed
SOG: Speed over
the ground
STW: Speed thru
the water
[Graphic]
analog format
[Numeric]
digital format
1.23
15.67
1.23
3-axis Speed
*
CCRP (Consistent Common Reference Point) is determined at installation, and is either the bow,
transducer location or center of vessel.