2. CHART PLOTTER
2-26
[Tidal Currents Transparency]: Set the degree of transparency for the tidal currents
display.
[RADAR OVERLAY]
[Radar Transparency]: Set the degree of transparency for the radar echo.
[Range Link]: Activate or deactivate matching the overlay with radar ranges.
[Echo Color]: Tap the color for the radar echo.
[DEPTH SHADING VALUES]
[Depth Shading Transparency]: Set the degree of transparency for the depth shad-
ing overlay.
For the menu items [Auto Depth Shading Color Scale], [Minimum Value], [Maximum
Value], and [Depth Color Shade], see section 3.2.1.
[PBG Terrain Shading]: Set the value for PBG terrain shading, Off, Light, Medium,
Strong.
[3D DISPLAY]
For [Auto 3D Alti Exaggeration] and [3D Alti Exaggeration], see section 8.7.2.
[PBG FILTER]
[Use Speed Filter]: Enable or disable use of the speed filter. See section 8.7.2.
[Maximum Speed]: Set the ship speed threshold to use when [Use Speed Filter] is
activated.
[Reset Default Settings]: Tap this menu item to restore default settings for the [Chart
Plotter] menu.
2.13 NAVpilot Series Auto Pilot
This section shows you to how to enable use of the NAVpilot with your system. For
how to use the NAVpilot to steer to a point, see subsection 4.15.4.
The FURUNO NAVpilot Series Auto Pilot installs in the NavNet TZtouch2 network to
get automatic steering when going to a point or a route. The following NAVpilot func-
tions can be controlled from a NavNet TZtouch2 display:
• Control operation of the NAVpilot from this equipment.
• Select the NAVpilot steering mode (Auto or Nav).
• Set up the NAVpilot-300 (see subsection 2.13.4).
Note 1: When an alarm message for the NAVpilot appears, check the control unit of
the NAVpilot.
Note 2: To enter points or routes from your NAVpilot series Auto Pilot, see
section 4.15.4 and section 5.11.11.
To Next Page
Loading...
