1. SYSTEM INTRODUCTION
1-37
[Home]: Open the home screen (see section 1.6).
[Settings]: Open the [Settings] menu (see section 1.15).
[Lists]: Open the lists menu (see section 1.15 and section 4.7).
[Tide]: Open the tide graph (see section 1.15 and subsection 3.2.4).
[Gain Control]: Open the gain adjustment slider bar in the radar, fish finder, or
multi beam sonar mode. See section 6.3 (radar), section 7.5 (fish finder).
[Anchor Watch Alarm]: Turn the anchor watch alarm on or off (see
section 2.10.5).
[Edge Swipe]: The arrow keys shown in the
right-hand figure appear on the screen. While
displayed, you can “edge swipe” with the option-
al remote control MCU-002, joystick of the
MCU-004, EDGE key, cursor pad or scroll pad
of the MCU-005, and the cursor pad of the
TZTL12F/TZTL15F.
[Fusion]: Open the Fusion screen (see section 11.1).
[Fusion Bar]: Show the Fusion operation bar (see section 11.2).
3. Tap the close button on the title bar to finish.
1.17 Language
The default interface language is English (United States). To change the language, do
as follows:
1. Go to the Home screen, then tap [Settings]→[General]→[Language].
2. Tap the language to use. The message "APPLICATION HAVE TO RESTART
NOW! DO YOU WANT TO RESTART APPLICATION?" appears.
3. Tap [OK].
The system takes approximately five minutes to optimize the system for the new
language setting,
For TZTL12F, TZTL15F users, when the process is completed, the power switch will
change color to orange. Press the power switch to start the system.
For TZT2BB users, if you have a monitor connected to the HDMI OUT1 port, the
monitor become blank when the optimization process completes. Press the power
switch to restart the system. If you have a monitor connected to the HDMI OUT2 port,
the system automatically restarts when the optimization process completes.
To Next Page
Loading...
