Furuno NAVNET TZ2 TZTL12F - How to Measure the Range with the VRM

6. RADAR
6-9
6.8.5 How to measure the range with the VRM
The VRM is a dashed ring so that you can identify the VRM from the fixed range rings.
Method 1: Using the EBL/VRM box in the data area
1. Referring to section 1.9.3, add the [EBL/VRM] data box to the [RADAR] data area.
2. Display the data area, then tap [RADAR].
3. Tap the VRM indication in the [EBL/VRM] data box.
4. Operate the VRM so that it rests on the inner edge of the target. Drag the VRM on
the radar display, drag the slider bar, drag the VRM indication box, or tap the “+”
or “-” symbol. The current VRM range is shown in the VRM indication box.
5. Tap [End VRM] at the top of screen to finish.
6. To clear the VRM, open the pop-up menu, then tap [VRM]→[Clear].
Drag
VRM
EBL/VRM
box
Tap
OR
Tap [End VRM]
to anchor VRM
and exit.
Drag slider or tap bar
(or tap +, - symbol).
XXXXX
Range to
object
Range to
object
Drag
VRM