Furuno NAVNET TZ2 TZTL12F - Initial Setup Menu

15. OTHER FUNCTIONS
15-5
15.3 Initial Setup Menu
The [Initial Setup] menu, which is mainly for use by the installer of the equipment, sets
up the system according to the sensors connected. These adjustments require some
knowledge of marine electronics equipment. If you are unsure of your abilities, have a
qualified marine electronics technician make the adjustments. Inadequate adjustment
can affect performance.
[GPS POSITION] section
[BOAT INFORMATION] section
[Boat Speed] Select the unit for the boat speed.
[Knot], [Kilometer per Hour], [Mile per Hour], [Meter per Second]
[Wind Speed] Select the unit for the wind speed.
[Knot], [Kilometer per Hour], [Mile per Hour], [Meter per Second]
[Atmospheric Pressure] Select the unit for the atmospheric pressure.
[HectoPascal], [Millibar], [Millimeter of Mercury], [Inch of Mercury]
[Oil Pressure] Select the unit for the oil pressure.
[KiloPascal], [Bar], [Pound per Square Inch]
[Volume] Select the unit for the volume.
[Gallon] (Gallon & Gallon/Hour), [Litre] (Litre & Litre/Hour)
[Reset Default Settings] Restore default settings for the [Units] menu.
Menu item Description Options (setting range)
[Longitudinal (from
bow]
Enter the GPS antenna posi-
tioning bow-stern (Longitudi-
nal) and port-starboard
(Lateral) position from the
origin.
0 m to 999 m
[Lateral GPS Position
(-Port)]
-99 m to +9 m
Menu item Description Options (setting range)
[Boat Length] Set the length of your boat. 0 (m) to 999 (m)
[Boat MMSI] Set your boat’s MMSI. Max. 9 characters
[Boat Name] Set your boat’s name. Max. 32 characters
[Size of Own Ship Icon] Set the size of own ship\ icon\. 50 to 150
[Depth Display] Select the start point for depth measure-
ment. Selection is indicated in the depth
box as "(K)" for [Under Keel] and "(S)" for
[Under Sea Level].
[Under Keel],
[Under Sea Level]
[External Transducer
Draft]
Set the draft external transducers other
than internal fish finder, networked or
multi-beam sonar.
For internal/network transducers, set
the draft from Home screen→[Set-
tings]→[Fish Finder]→[Transducer Draft].
For multi-beam sonars, set the draft
from Home screen→[Settings]→[Multi-
beam Sonar]→[Initial Setup]→[External
Transducer Draft].
0.0 (m) to 99.9 (m)
[Keel Draft] Set the keel draft. 0.0 (m) to 99.9 (m)
Menu item Options
OriginOrigin