Furuno NAVNET TZ2 TZTL12F - How to Enter Points, Event Marks; How to Enter a Point (Chart Plotter and Radar Displays Only)

4. POINTS, BOUNDARIES
4-2
4.2 How to Enter Points, Event Marks
4.2.1 How to enter a point (chart plotter and radar displays only)
Method 1: Directly on-screen
1. Tap the position on the screen where to put a point.
2. Tap [New Point] on the pop-up menu.
The default point icon is put at the position selected, and the point is saved to the
[Points] list.
Method 2: Manual input (chart plotter, radar, weather)
Open the Slide-out menu, then tap [Position Entry]. The position shown is latitude/lon-
gitude of the center of the displayed area. Edit the position as required. Tap [] to reg-
ister the point and close the keyboard.
Example pop-up: chart plotter display
Cursor (light blue)
Latitude and longitude for
displayed screen’s center.
Move cursor.
Switch coordinate
(N↔S, E↔W).
Position display format
Select position display format from pull-down menu.
Set point as
destination (see
section 4.15).
Open point editing
screen (section 4.10).
Put point at center of screen.
(Point is highlighted for seven
seconds.) Point is registered to
Points list.