Furuno NAVNET TZ2 TZTL12F - Chart Information; How to Find the Range and Bearing between Two Locations

2. CHART PLOTTER
2-7
2.6.2 Chart information
Tap a location on the chart not occupied by a chart object, then tap [Chart Info] on the
pop-up menu.
2.7 How to Find the Range and Bearing Between
Two Locations
The [Distance] item in the Slide-out menu measures the range and bearing between
any two locations on your chart. Range and bearing between the two locations are dig-
itally indicated on the screen.
1. Open the Slide-out menu.
2. Tap [Distance].
A dashed line runs between the start location and the 2nd location. The range,
bearing, SOG, and TTG to the 2nd location is shown at the top of the screen.
3. To change the location of either point, drag and drop.
4. To quit the distance measurement, tap [Cancel Ruler] at the top right-hand corner
of the screen.
Range Bearing Speed Over the Ground Time To Go
Starting
location
End
location
Icon
Drag to change location.