EasyManua.ls Logo

Furuno NAVNET TZ2 TZTL12F - Wind Speed Alarm; Low Fuel Alarm; Other Alarm Menu Items

Furuno NAVNET TZ2 TZTL12F
420 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. CHART PLOTTER
2-16
Anchor watch position averaging
The anchor watch position may vary depending on received GPS position. If the posi-
tion changes often, you can average it to prevent random changes. The higher the set-
ting value, the greater the degree of averaging. However, if the averaging is set too
high, the calculation of position may slow.
1. From the [Alarm] menu, tap [Anchor Watch Position Averaging].
2. Select a position averaging time.
3. Tap the close button on the title bar to finish.
2.10.6 Wind speed alarm
The wind speed alarm tells you when the wind speed is over or under the limit set. Set
the value at [Wind Speed Alarm Value].
1. Tap [Wind Speed Alarm] on the [Alarm] menu.
2. Tap [Apparent] or [True] as required.
[Apparent]: Triggers the alarm when the apparent wind speed exceeds the set
speed.
[True]: Triggers the alarm when the true wind speed exceeds the set speed.
3. Tap [Wind Speed Alarm Value] to display the software keyboard.
4. Set the wind speed value, then tap [].
5. Tap the close button on the title bar to finish.
2.10.7 Low fuel alarm
The low fuel alarm informs you when your fuel level drops below the setting percent-
age of fuel).
1. Turn on [Low Fuel Alarm] in the [Alarm] menu.
2. Tap [Low Fuel Alarm Value] to display the software keyboard, set the value, then
tap [].
3. Tap the close button on the title bar to finish.
Note: To disable this alarm, turn it off at step 1 of the above procedure.
2.10.8 Other Alarm menu items
The followings are the alarm menu items not previously mentioned.
[Hardware Alarm]: The [OFF] setting disables hardware-related alarms.
[Notification Sound]: Activate or deactivate the notification sound (for "Waypoint
Crossing" (see section 5.10), "End of Route" (section 4.15) or fish finder alarms
(section 7.13)).
[Notify when NAVpilot is engaged]: Turn on to get notified (beeps) when the auto-
matic steering device is engaged or disengaged, and when the safe helm is activated
or deactivated.
[Alarm Sound]: Disable or enable the buzzer.

Table of Contents

Related product manuals