Furuno NAVNET TZ2 TZTL12F - How to Transmit, Go to Stand-By; How to Select a Display; Single Frequency Display

7. FISH FINDER (SOUNDER)
7-2
7.2 How to Transmit, Go to Stand-by
Open the pop-up menu, then tap the flipswitch [TX/STBY]. Select [ON] to transmit;
[OFF] to go to stand-by. [Stand-by] appears at the screen center when in stand-by.
7.3 How to Select a Display
Your fish finder has six display modes. These modes are single frequency, dual fre-
quency, bottom zoom, bottom lock, A-scope, and bottom discrimination.
7.3.1 Single frequency display
The single frequency display shows either the low-frequency or high-frequency picture
on all the screen. Select a frequency according to your purpose.
• A low frequency gives a wide detection area. Use the low frequency for general
search and to find bottom conditions.
• A high frequency gives better resolution. Use the high frequency to inspect a school
of fish.
How to select a single frequency display
1. Open the Layers menu.
2. Tap [Single Freq] at [Display Mode].
3. Turn on [Single Freq.].
High
freq.
Low
freq.