5. ROUTES
5-23
The screen shows the SAR and the SAR area, a dashed rectangle.
7. To change the search commence point, drag the icon marked as (A) in the figure
above.
8. If necessary, change the bearing search area by dragging the icon marked as (B)
in the figure above.
9. Tap [End SAR] to finalize the SAR area.
10. Tap [OK] to start SAR operations.
If the NAVpilot-700 series is engaged and activated (see section 2.13.1) in the
system, the message "DO YOU WANT TO NAVIGATE USING THE NAVPILOT?"
appears. Tap [Yes] to have the NAVpilot steer the vessel, then the NAVpilot auto-
matically goes into the NAV mode. For the NAVpilot-300, you are asked to select
a navigation mode.
11. Select [Precision] or [Economy]. ([Cancel] stops the NAV mode.)
Precision: Keeps XTE within 0.01 NM
Economy: Keeps XTE within 0.03 NM
(A)
(B)
Example 2: Sector Search
Example 1: Expanding Square
(A)
(B)
Example 1: Parallel/Creeping Line
(A) (B)
To Next Page
Loading...
