15. OTHER FUNCTIONS
15-2
Menu item Function Options
[Move Tool on
Long Push]
Enable the "move" function with long-push of an
object. Applicable to;
• Points/event mark icons (excluding Sounder)
• Route waypoints
• Guard zone
• EBL/VRM
[OFF], [ON]
[Display Addi-
tional TD in Nav-
Data]
In the [ON] setting, the TD information is added to
the own ship’s position in the data area.
[OFF], [ON]
[Edge Swipe
Guide]
When you switch the display screen, or close the
menu or list and return to the display screen in the
[ON] setting, the indication shown below appears
for about 15 seconds at the top, bottom, left and
right of the screen. When swiping the indication,
the functions appear (see section 1.8). The indica-
tion disappears when you operate the screen.
[OFF], [ON]
[User Interface
Auto-Hide]
Select the timeout for the following menus and the
home icon on the camera/instrument screen (full
screen).
• Layers menu
• Slide-out menu
• Pop-up menu
• Quick page
Note: The home icon always appears on the split
screen camera/instrument display and other dis-
plays.
[0’03s], [0’05s], [0’10s],
[0’15s]
[Auto Scroll] In the [ON] setting, the chart is appropriately and
automatically scrolled when the cursor goes out of
the display area.
[ON], [OFF]
[Cross Cursor
Speed]
Adjust the cross cursor speed. -7 to +7
[Allow Remote
Control]
Sets the permission level for NavNet Remote.
[Off]: Connection with NavNet Remote not al-
lowed.
[View Only]: Can view the screen remotely, but
cannot operate and functions.
[Full Control]: Can operate the entire system by
remote.
[Off], [View Only], [Full Con-
trol]
[Local Time Off-
set]
Select the time difference between local time and
UTC time.
UTC -12:00 to UTC +13:00
(at 15 minute intervals)
[Time Format] Select how to display time, in 12 or 24 hour format.
[Auto] automatically inserts AM, PM indication in
24 hour clock, when the language is English.
[Auto], [24 Hours], [12
Hours]
[Demo File] Select the demo file (internal or external) to use in
the demo mode. For external data, set the appli-
cable media in the SD Card Unit or the USB port.
[Stop Demo] Stop the demo mode selected at [Demo File]. -
TD (time difference)
information
To Next Page
Loading...
