2. CHART PLOTTER
2-29
AUTO mode
Tap [AUTO] on the manual mode to switch to the NAV mode. The figure below shows
an example AUTO mode data box.
* The steering step interval (2 - 30°) can be set with Home icon→[Set-
tings]→[Routes]→[NAVPilot Steering Step]. Use the slider bar or software keyboard.
Do one of the following to set course:
• Use the course setting buttons to set course.
Tap or for change in 1° increments.
Use the steering step interval buttons ( ), ( ) to set course in step intervals.
• Tap the set course line to display the pop-up window
shown in the right-hand figure. Tap [Adjust]. Drag the
set course line to set course. Tap [Finish] to complete
the adjustment.
Heading
Set course
HDG
Tap within this area to
switch to the manual
(stand-by) mode.
Turn/Menu button
Shown only with connection
of NAVpilot-300.
Course setting buttons.
(Red=Port, Green=STBD)
Tap the single arrow for fine (1º) adjustments;
Tap the double arrow for step* adjustment.
Adjust
To Next Page
Loading...
