36 G-TECH / Pro Competition User Guide, Release 3.1
For more information on accelerometers, calibration, and
accuracy, please refer to “Accelerometer Tips” on page 142.
Mounting the G-tech
The G-tech is shipped with a sophisticated mounting system
that is used to hold the G-tech steady in your vehicle.
This section describes:
• the different pieces of the mounting bracket
• how to assemble the mounting bracket
• how to mount the bracket in your vehicle
Note: In order to obtain accurate measurements, the G-tech
must be mounted properly. Please read this section carefully, it is
very important!
For directions on removing the mounting bracket from
your windshield, please refer to “Removing the bracket” on
page 150.
For directions on permanently mounting the bracket in
your vehicle, please refer to “Permanent Mounting” on
page 151.
Note: DO NOT CALIBRATE ACCELEROMETERS or ERASE ACCELEROMETER CALIBERATION
on G-tech units which were shipped after August 2003. They have already been calibrated in the
factory. Older G-techs will automatically request calibration. If you are unsure contact tech support.
To Next Page
Loading...