102 G-TECH / Pro Competition User Guide, Release 3.1
Setting U.S. or Metric Mode
The G-tech can display units in U.S. mode (feet, pounds,
miles per hour, etc.) or Metric mode (meters, kilograms, kilo-
meters per hour, etc.).
Set the G-tech to operate in whichever mode you prefer to
view data.
Note:
When you switch between metric and U.S. modes, it
affects only how the data are displayed, not how the data are
saved inside the G-tech.
In other words, you can switch between metric and U.S. modes
at any time, without losing any configuration information or vehi-
cle measurements.
The following table lists the units for each configuration item
in the G-tech, both in U.S. mode and Metric mode:
When performing and viewing runs, there are also corre-
sponding measurements in both modes:
The G-tech measures and stores both full sets of measure-
ments on every run, regardless of which mode you are in. In
other words, even if you perform a run in U.S. mode, the G-
tech is also monitoring and storing all the metric milestones
as well, and vice versa.
Item U.S. unit Metric unit
Weight lbs kilograms
Speed miles per hour kilometers per hour
Distance inches, feet cm, meters
Power horsepower kilowatts
Torque ft-lbs newton-meters
U.S. Mode Measurement Metric Mode Measurement
60 ft time 20m time
330 ft time 100m time
1/8 mile time and speed 200m time and speed
1000 ft time 300m time
1/4 mile time and speed 400m time and speed
0-60 MPH time 0-100 km/h time
Item U.S. unit Metric unit
To Next Page
Loading...