72 G-TECH / Pro Competition User Guide, Release 3.1
Results
The “Results” menu entry provides you with all the informa-
tion you’d get from a dragstrip timeslip, including milestones
such as 60 ft. time, 1/8 mile time and speed, etc. For runs per-
formed with a reaction time start mode (
p. 129), your reaction
time is given as well.
For more information on the “Results” menu entry, please
refer to “Viewing Run Results” on page 55.
HP & Torque vs RPMs
One of the most exciting features of the G-tech is its ability
to measure and graph your vehicle’s horsepower and torque
against an RPM range.
The G-tech’s “HP & TQ vs RPM” menu entry provides you
with a graph of horsepower and torque in an RPM range.
This is the “dyno plot” that everyone is accustomed to see-
ing.
After you perform a run, the G-tech analyzes the data and
then creates a graph based on the gear in which maximum
horsepower was attained.
Note: In order for you to get consistent HP & TQ graphs,
there is an optimal driving technique to use. This technique is
different than the driving technique you would use for a quick 1/
4 mile!
Please refer to “Horsepower, Torque & G-tech” on page 157 for
more information on optimal technique for performing horse-
power runs.
To Next Page
Loading...