GE AMX 4+

 
         
   
5-8
       
To remove the hand switch cable
1. Disconnect the cable from the connector on the body of the AMX-4+.
2. Remove the 6-32 screw securing the cable clamp, then remove the clamp and
star washer.
To install the hand switch cable, perform the above steps in reverse order. Be sure to
align the cable to the cover as indicated in Illustration 5-6.
ILLUSTRATION 5-6
  
COIL CORD
6–32 SCREW
P CLAMP HANDSWITCH LABEL
STAR
WASHER
RIGHT SIDE COVER
LINE CABLE UP
PARALLEL TO EDGE
OF COVER BEFORE
TIGHTENING DOWN
CLAMP