GE AMX 4+ Technical Manual

 
         
   
9-1
 
    
This section provides procedures covering the removal and installation of the high
voltage transformer.
!  
  
1. Shut power off by turning the circuit breaker OFF.
2. Remove front cover by carefully pulling cover from four ball stud retainer sockĆ
ets.
3. Disconnect anode and cathode cables from high voltage transformer.
4. Remove two cap screws holding rear cover on base assembly and remove cover.
5. Remove cassette drawer. Refer to Section 5-1.
6. Remove cassette drawer magnetic strip lock by removing three binding head
screws and flat washers.
7. Remove high voltage transformer terminal cover by removing two binding head
screws and washers. See Illustration 9-1.
ILLUSTRATION 9-1
  
  
 
 
 

 
 
 

GE AMX 4+ Specifications

General

Type	Mobile X-ray System
Maximum kVp	125 kVp
Collimator	Manual Collimator
Battery	Rechargeable, lead-acid
Image Receptor Compatibility	CR and DR systems
Focal Spot Size	1.2 mm
mAs Range	0.04 - 320 mAs
X-ray Tube	Rotating Anode