REV 5 DIRECTION 2173225-100
6-1
During removal:
D Reference to the right and left sides of battery compartment are relative to
the view shown in Illustration 4.
D Cable numbers (#s) indicated in Illustration 6-3 and in this instruction are
marked on the parts.
D Insulator numbers are shown for convenience in description, but are not
marked on the parts.
D There are no Insulators #3 and #7.
D Battery numbers may or may not be marked on batteries. Mark batteries
with numbers if desired.
D Disconnect cables only in the order instructed, and only when instructed.
D Don't remove paper backing from any insulating separator pad.
( !"#&! %%!$' #&!$
1. Place the unit on a level floor. Extend the horizontal arm and rotate it to the front
end (vertical column end) of the unit. See Illustration 6-1.
#%! Distribution of weight is necessary to remove the battery compartment cover.
ILLUSTRATION 6-1
COVER CAPSCREWS
CABLE MARKED #4
BATTERY
GROUND STUD
BASE ASSEMBLY
BATTERY
COMPARTMENT
CABLE MARKED #2
CIRCUIT
BREAKER
To Next Page
Loading...
