7-4
& # $ !" "%
Lifting can be done with:
D Automotive floor jack (minimum 1200 lbs. (550 kg) capacity).
D Lever (2 4 inches, palette lever) (5 cm 10 cm).
D Chain hoist.
D AMX-4 Series lifting jack, 46-302966P1.
It is STRONGLY RECOMMENDED that the unit be lifted using the AMX-4 Series
lifting jack. This instruction is based on the use of this tool.
Get the 46-302966P1 AMX-4 lifting jack and note the two lips on the front of the
jack. See Illustration 7-4.
ILLUSTRATION 7-4
&& Raise Rear Wheels
1. Rotate front wheel caster toward rear, otherwise unit will be unstable when rear
of unit is raised.
2. Block the front wheel and lift drive wheel end of base assembly approximately
10 inches (25 cm) and place it on blocks.
3. Place blocks under wheel being removed to prevent it from falling when axle supĆ
ports are removed.
&& Lower Rear Wheels
1. Put the jack under the rear of the AMX unit USING THE TWO LIPS ON THE
FRONT OF THE JACK, and lift the AMX unit enough to remove the wood
block(s).
2. Lower the AMX unit and remove the jack.
To Next Page
Loading...
Need help?
General
