GE NetworX V3 User Manual

NetworX Version 3 Installation Manual
167
Location Term Definition
the alarms until they have been viewed.
3.3.14.10 Display Contact Central Station A menu option that, if enabled, sets the keypad to display
the message Contact Central Station after an alarm has
been reported and the system disarmed.
3.3.14.11 KP Shutdown shows Clock A menu option that causes the keypad to display the date
and time instead of the "Please Enter Your Code" message.
3.3.14.12 KP Shutdown allows Disarm A menu option that, if enabled, allows a blanked keypad to
be disarmed.
3.3.14.13 Status LED A menu option that, if enabled, turns on the backlighting
for the state indicator (GE logo) on the keypad.
3.3.14.14 Status LED Always On A menu option that, if set to Yes, causes the state indicator
to be on at all times. This option is accessible only on a
wired keypad.
3.3.15 Pry Off Switch A menu entry that groups the wireless keypad options
related to the pry off switch.
3.3.15.1 Always Tamper A menu option that turns on the wireless keypad's pry off
switch. It actually fixes the wireless keypad to the wall just
like a wired one, while disabling this option renders the
keypad fully portable within the reach of the RF link.
3.3.15.2 Only Arm-away if On the Wall A menu option that allows to arm the system in Away
mode only if the wireless keypad is on the wall.
3.4 Function Keys A menu entry that groups all programmable function key
options.
Function keys are dedicated for a particular function as
programmed by the installer. See Programming the
function keys on page
154.
3.5 Set KP Language A menu option that selects the keypad interface languages
available to the user. It is possible to select up to four
languages (Language 1 to 4) out of all available interface
languages. The languages selected here, can be then
toggled by the user (or installer) with the OK key.
3.6 Program KP Text A menu entry that groups the language options of the
current keypad. It allows the installer to set options such as
zone name descriptors and user names.
3.6.1 Zones/Messages A menu entry that groups descriptors, such as zone names
and custom messages. These names and messages are
language dependent, for example, setting a display
language also changes displayed zone names to the ones
defined for this language.
3.6.1.1.1 Zone Names A menu option that specifies the name of each zone and
allows these names to be edited.
3.6.1.1.2 Partition Names A menu option that specifies the name of each partition.

GE NetworX V3 Specifications

General

Brand	GE
Model	NetworX V3
Category	Security System
Language	English