EasyManuals Logo
Home>GE>Security System>NetworX V3

GE NetworX V3 User Manual

GE NetworX V3
286 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #206 background imageLoading...
Page #206 background image
NetworX Version 3 Installation Manual
206
Report type
Information
required
Menu Option
Allow the user to
send HomeText
commands from
any phone.
Select NX-7002 Module>Reporting>HomeText>Any Phone
Access>Users n
Note: Sending a HomeText message from the unregistered phone
requires the following syntax:
[Registered Phone Number] [password] command [values]
TCP/IP network connection
GPRS Access Point
Number
Select NX-7002 Module>Options>Network>GPRS APN.
PPP Login Select NX-7002 Module>Options>Network>User ID.
PPP Password Select NX-7002 Module>Options>Network>Password.
TCP/IP Alarm Port Select NX-7002 Module>Options>Network>Port Numbers>TCP/IP
Alarm Port.
This should match the port number on the receiver side.
Status Check Select NX-7002 Module>Options>Status Check>GSM Connection>GPRS
Connected.
TCP/IP reporting Destination Select NX-7002 Module>Reporting>Report Control>Report
n>Destination>TCP/IP 1 or 2.
IP address Select NX-7002 Module>Reporting>TCP/IP
Reporting>Receivers>Receiver n>IP Address.
Account Code Select NX-7002 Module>Reporting>TCP/IP
Reporting>Receivers>Receiver n>Account Code.
Note: SIA account numbers are 6 digits long. Contact ID account
numbers are 4 digits long. Add leading zeros to create an 8-
digit number.
Receiver Number Select NX-7002 Module>Reporting>TCP/IP
Reporting>Receivers>Receiver n>Receiver Number.
Line Number Select NX-7002 Module>Reporting>TCP/IP
Reporting>Receivers>Receiver n>Line Number.
Protocol Select NX-7002 Module>Reporting>TCP/IP Reporting>Report
Format>SIA.
Enable Polling Select NX-7002 Module>Reporting>TCP/IP Reporting>Polling Time.
Up/downloading over GSM
GSM Data Phone
Number
Select NX-7002 Module>Up/Download>Phone Number.
Note: Use the DL900 version that supports GSM downloading.
Allow Calls from
Select NX-7002 Module>Up/Download>Allow Calls From.
Note: Only allows incoming data calls from specific phone
numbers.
Connection Type Select NX-7002 Module>Up/Download>Connection Type>CSD.
Up/downloading over GPRS
GPRS IP address Select NX-7002 Module>Up/Download>IP Address.
Note:
Use the DL900 version that supports GPRS downloading.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE NetworX V3 and is the answer not in the manual?

GE NetworX V3 Specifications

General IconGeneral
BrandGE
ModelNetworX V3
CategorySecurity System
LanguageEnglish

Related product manuals