NetworX Version 3 Installation Manual
220
Term Definition
Line Fault RF Level
An Options setting that configures the acceptable level of the RSSI signal. If the signal falls below this
level for the amount of time set in Line Fault Delay, a line fault is generated. This can be from 1 to 31.
If set to 0, the setting is disabled.
Line Number A Reporting setting that configures the line number associated with the selected receiver account.
Logged into GSM
Network
An Options setting that indicates that the GSM module is logged into the GSM network.
M
Manufacturer An Options setting that contains the GSM Engine Manufacturer Identification.
Max Joined SMSs
A Reporting option that sets the maximum number of text messages that can be joined together and
sent as a single SMS.
Max Report Attempts
A Reporting setting that configures the number of attempts the NX-7002 makes to send a report. This
can be from 0 to 15.
Max Reports in 24h
A Reporting setting that configures the maximum number of reports that can be sent by the NX-7002
in 24 hours. The NX-7002 stops reporting when the number of messages in a 24 hours exceeds this
number. This can be from 1 to 255. If set to 0, there is no limitation. This applies to SMS and TCP/IP.
Max U/D
Authentication
Attempts
An Up/Download setting that contains the maximum number of attempts that are made each time
the Up/Download report is made. After this number of attempts, the system is disabled for the length
of time set in U/D Authentication Disable Time.
Mode
An Options setting that configures the mode used for site initiated CSD GSM calls. If you are
experiencing problems with upload/download, change this setting from transparent mode to non-
transparent mode or vice versa.
See also Transparent mode and Non-transparent mode
Model A menu option that displays the current model of the GPRS module.
Module address
A NetworX bus module number is assigned to each system module. The system uses this number to
identify the module. It is also used to report module problems (such as tampers and module
supervision lost) to the central station. The NX-7002 module address is 78.
N
Network An Options menu entry that groups network options.
Non transparent
mode
An operating mode for CSD on a GSM network. An intermediate modem is used on the network to
transfer data from one modem to another.
O
Only Registered
Phones
An Options menu setting that allows commands to be accepted only from registered HomeText
phone numbers.
Opening/Closing
A Reporting setting that sends a report to the selected report control stating when the system is
opened (disarmed) and closed (armed).
Operator Selection
An Options setting that configures the GSM network operator used by the NX-7002. Set this to 00000
to allow the SIM card automatically select a network operator. Alternatively, enter an operator ID
code to manually select a network operator.
The Logged into GSM Network message does not appear if an invalid selection is made or the
network is unreachable.
Options A menu entry that groups the NX-7002 options.
P
To Next Page
Loading...
Need help?
General
