GE NetworX V3 - Page 266

NetworX Version 3 Installation Manual
266
Message Definition Action
CleanMe
A specific smoke
detector (for example,
DP721) is dirty. The
panel detects a degree
of pollution in the
chamber of the
fire/smoke detectors.
Clean the detection chamber of the smoke
detector.
Note: This message is not shown on the LCD
display, only listed in the event log.
Open
There is a problem
with the wiring.
Check the zone and zone sensors for damage and
repair any faults.
Note: This message is displayed in case of wired
zones only.
Lost
The system has not
received RF sensor
transmissions for a
long period of time.
Depending on how the
system is
programmed, this
condition activates a
service report. In
addition, it may
activate a tamper
alarm if armed.
Ensure that the wireless zone module is receiving
power and has not been tampered with. Repair
any faults.
Low Battery
An RF sensor battery is
low.
Replace the battery.
Short Loss
The system has not
received RF sensor
transmissions for a
short period of time.
This condition prevents
arming.
Ensure that the wireless zone module is receiving
power and has not been tampered with. Repair
any faults.