NetworX Version 3 Installation Manual
80
Location Term Definition
2.4.1.1.1.6.4 Communications A menu entry that groups together the communication
events that are reported to the selected phone number.
2.4.1.1.1.6.4.1 Fail to Communicate A menu option that reports a fail to communicate event to
the selected phone number.
2.4.1.1.1.6.4.2 Test Reports A menu option that sends a test report to the selected
phone number at pre-programmed intervals. The units can
be set in days or hours.
2.4.1.1.1.6.5.1 Program/Download A menu option that reports programming and
up/download events to the selected phone number.
2.4.1.1.1.7 Partitions to Report A menu option that specifies which partitions are reported
to the selected phone number.
Important: When you select a partition, ALL events from
this partition are reported to the assigned central station,
and individual event settings selected in the Events section
are disregarded. If you want to select individual events to
be reported to the particular phone number, do not set any
partitions in this location.
2.4.1.2 Partition Account Codes A menu option that lists the account codes for each
partition. The account code is sent when the relevant
partition is reported.
2.4.1.3 Dialer Auto Cancel/Abort A menu option that makes the Cancel and/or Abort
features of a dialer automatic when the system is
disarmed. It means that pressing the Cancel button
(programmable function button) is not required after a
disarm code is entered. The Cancel and Abort features
must be enabled to permit this Auto feature to work. For
proper operation of these features, "Dialer Abort Delay"
must be enabled in the zone configuration group.
2.4.2 Up/Download A menu entry that groups options used to control
download sessions between the up/download software
and the control panel.
2.4.2.1 Callback Phone Number A menu option that specifies the telephone number that
the control panel dials if the Callback Required option is
enabled.
2.4.2.2 Download Access Code A menu option that specifies the eight-digit access code
sent by the up/download software to the control panel. The
panel permits downloading to occur when it receives this
code.
2.4.2.3 Call Back Reqd A menu option that controls access of the up/download
software to the control panel. When the software calls the
control panel, the panel answers the call and then hangs
up. After approximately 36 seconds, the panel calls the
software back.
2.4.2.4 Rings to Answer A menu option that sets the number of rings that must
occur before the panel answers to start a download
session. If the value is 0, the panel will never pick up the
phone line.
To Next Page
Loading...
