GEM WK6

○○○○○○○○○○○○○○○○○○○○○○
Edit Controllers/Pads 13•1
• 13 Edit Controllers/Pads
In «Edit Controllers/Pads» you can program how
the individual tracks of a Performance react to
the Trackball, the programmable Pedals and pro-
grammable Pads.
Press the CNT./PADS button in the EDIT section
to gain access to the «Edit Controller/Pads” en-
vironment.
○○○○○○○○○○○○○○○○○○○○
©
Note: Save the changes with STORE
PERFORMANCE. The Performances memorize
○○○○○○○○○○○○○○○○○○○○
the pages whose icon shows the symbol .
WHEELS (F1)
Activates the action of the Wheels for single
tracks.
Each track can be independently programmed
for the action of the Pitchbend Wheel (1) and/or
the Modulation Wheel (2).
PitchBend 1
Pitch Bend is applied by vertical movements of
Wheel 1 (the left wheel). The PitchBend wheel
is spring loaded to return the control to the cen-
tral position (corresponding to standard pitch).
The parameter offers a maximum pitch excursion
of 12 semitones and Off.
The same control can be assigned to a continu-
ous control pedal. See “Pedals Programming
(F2)” .
Edit Controllers/Pads - Wheels
Pitch/Mod assignment for each track
Performance
Track in edit
CNT
/ P
ADS
4
Modulation 2
Modulation is applied by vertical movements of
Wheel 2 (the right wheel). The Modulation Wheel
is centre-dented for easy positioning at the cen-
tral position. The parameter can be set to either
On of Off.
The same control can be assigned to a switch
action pedal. See “Pedals Programming (F2)” .
Options: Pitch Bend: Off, 1...12.
Modulation: Off, On.