○○○○○○○○○○○○○○○○○○○○○○
User Guide 2•1
Chapter 2 • User Guide
POWER UP
1. Be sure that the power switch on the rear panel
is in the “OFF” position.
2. Connect the power cord to the rear panel mains
socket and insert the other end of the power cord
into a suitable grounded wall outlet.
3. Connect the audio cables
Connect the stereo audio outputs (Left, Right)
to your amp. system (mixer, powered speak-
ers, etc.) using audio cables with standard 1/
4” jacks. Use RCA jacks to connect to do-
mestic stereo units. For mono reproduction,
connect to either the Left or Right jack.
4. Press the power switch to turn on
SK760/880
.
After a few seconds the instrument sets to
the default situation.
The power up display shows a single sound
(Piano 1) active.
5. Play on the keyboard and you will hear the Pi-
ano 1 sound play across the full keyboard.
If necessary, regulate the display contrast with
the DISPLAY CONTRAST panel knob on the
right of the display.
Different viewing angles may require an ad-
justment of the contrast.
The display reaches its maximum brightness
a few minutes after turning on.
1
2
4
5
CONTRAST
To Next Page
Loading...
Need help?
General
