○○○○○○○○○○○○○○○○○○○○○○
Disk & Hard Disk 3•27
1/2
3/4
Move operations
Use the Move command to shift a file from one
location to another within the same device, or from
the Hard Disk to floppy (bypassing the RAM) and
vice versa. This option cancels the file at the
source.
○○○○○○○○○○○○○○○○○○○○
©
WARNING - Use the Move function only in
○○○○○○○○○○○○○○○○○○○○
cases where the original file is to be cancelled.
Models without a Hard disk can move files from
within the same floppy or within RAM.
To move a file from one floppy disk to another,
first load the file to RAM, then save it to the other
floppy.
The example which follows shows how to use
the Move operation within RAM (Move Single
Sound), and provides sufficient information which
you can apply to all Move situations.
1. Press DISK to open the main Move page.
If the main Move page is not shown, use the
page scroll ( ) buttons to open it.
2. Select the MOVE command required from the
main page.
3. Select the source and destination devices with
soft buttons F1, F2 or F3.
In this case, select RAM as the device to work
in. Selecting «Floppy disk» or «RAM» auto-
matically assigns the same device to source
and destination.
4. Press ENTER to enter the file selector.
DISK
H.
To Next Page
Loading...
Need help?
General
