○○○○○○○○○○○○○○○○○○○○○○
User Guide 2•21
THE SOLO BUTTON - ISOLATE A SINGLE
SOUND FROM THE REST
If you are playing in a situation where two or more
sounds are displayed, before activating a muted
sound you may want to listen to it alone to de-
cide whether to activate it or not. In such a situ-
ation, you can isolate the sound from the rest
using the SOLO button in the following manner:
1. Press the SOLO button and play on the keyboard.
The LED of the SOLO button turns on and
the sound currently shown highlighted will
play while all other sounds are automatically
muted (if active).
2. Select any another sound by pressing the corre-
sponding Soft button once only.
In this example, the sound WarmPad (Lower
2) is automatically activated and the previ-
ous one (E.G.Piano1) is automatically muted.
Observe that the sound plays across the full
keyboard: normally Lower 2 plays on the left
split in Upp/Low mode and cannot be acti-
vated when Full keyboard mode is selected.
In Full keyboard mode, therefore, even
sounds assigned to the Lower keyboard sec-
tions play across the full keyboard when they
are “Solo’d”. In other words, the SOLO but-
ton overrides the current Split point.
In Upp/Low and Multi mode, a Solo’d sound
plays across the currently assigned keyboard
extension. In this case, the SOLO button
recognises the current Split Point.
The SOLO button finds its principal use in
Multi track situations.
3. Press the SOLO button again to return to normal
operation.
The SOLO LED turns off.
1
< ------------------- WARMPAD (Lower 2) ------------------- >
SOLO
A
B
C
D
E
F
G
H
2
3
SOLO
To Next Page
Loading...
Need help?
General
