○○○○○○○○○○○○○○○○○○○○○○
Disk & Hard Disk 3•23
Erase operations
Use the Erase command to cancel files no longer
needed from a data storing device (Disk or Hard
Disk) or from RAM to make room for other files.
When you pass to the Erase page, you can
choose the device to erase data from with the
corresponding soft buttons:
• Floppy disk = F1
• Hard Disk = F2
• RAM = F3
The Erase File Selector does not operate be-
tween source and destination directories as in
the load and save file selector, but on a single
directory contained in the device you are cancel-
ling files from.
The example which follows shows how to Erase
a single Song from RAM.
1. Press DISK to open the main Erase page.
If the main Erase page is not shown, use the
page scroll ( ) buttons to open it.
2. Select the ERASE command required from the
main page.
3. Select the source device to erase from.
In this case, select the RAM option with soft
button F3.
If you are erasing from a floppy disk, insert
the disk into the drive and check that the
“Floppy Disk” option is selected (soft button
F1).
If you are erasing from the Hard Disk, select
the “Hard Disk” option with soft button F2.
4. Press ENTER to enter the file selector.
1/2
ENTER
TEMPO
ESCAPE
DISK
H.
To Next Page
Loading...
Need help?
General
