CAUTIONS:
• In USA, Federal law restricts this device
to sale by or on the order of a physician.
• The expiratory channel and expired gas
from the exhaust port may be
contaminated.
• Refer to the Installation instructions to
assemble the system or options to obtain
a proper mechanical assembly.
• Service, repair and installation must only
be performed by personnel authorized
by the manufacturer.
• When lifting or moving the ventilator
system or parts of the system, follow
established ergonomic guidelines, ask
for assistance, and take appropriate
safety precautions.
• Before use, make sure the system
version displayed under Status
corresponds to the system version
described in the User´s Manual.
• Extra care should be taken when
handling tubes, connectors and other
parts of the patient circuit. The use of a
support arm to relieve the patient from
the weight of the tubing system is
recommended.
• When using the MCare Remote Service
function, install the network cable so that
there is no risk of anyone tripping over
it.
• Do not leave the patient unattended
when connected to the ventilator.
• The manufacturer has no responsibility
for the safe operation of SERVO-s
Ventilator System if the Intended Use
requirements specified in this document
are not followed.
• Contact a representative of the
manufacturer regarding decommissioning
of the equipment.
• Disconnect the mains power cable from
the outlet to isolate the ventilator from
mains power.
• Do not touch accessible connector
contacts and the patient simultaneously.
Important:
• Always use a heat and moisture
exchanger (HME) or equipment to
prevent dehydration of lung tissue.
• Securely attach all cables, etc, to
minimize the risk of unintentional
disconnection.
• All excess fluids must be disposed
according to hospital routines.
10
SERVO-s VENTILATOR SYSTEM V8.0, User's Manual
| 1
| Introduction |
To Next Page
Loading...
Need help?
General
