• Do not modify or remove any original
parts.
• Do not cover the ventilator in any way,
since the functioning of the equipment
may be adversely affected.
• When the ventilator is used for MCare
Remote Service, use only network
equipment that is safe and in compliance
with the relevant electrical and EMC
standards such as IEC-60950.
Note:The network cable is excluded
from this requirement.
• Always disconnect the network cable
before starting ventilation when the
ventilator is used for MCare Remote
Service.
• Positive pressure ventilation can be
associated with the following adverse
events: barotrauma, hypoventilation,
hyperventilation or circulatory
impairment.
• The SERVO-s Ventilator System is not
intended to be used during radiotherapy,
since this may cause system malfunction.
• The SERVO-sVentilator System must not
be used in a hyperbaric chamber.
• The SERVO-s Ventilator System must not
be used with helium.
• Only accessories, supplies, and auxiliary
equipment recommended by the
manufacturer should be used with the
ventilator system. Use of any other
accessories, spare parts or auxiliary
equipment may cause degraded system
performance and safety.
• The power supply cord must be plugged
directly into the mains power outlet
without the use of any multiple socket
outlets. If a multiple socket outlet is used
together with other products, total
leakage current might be exceeded at
earth fault.
• Portable RF communications equipment
(including peripherals such as antenna
cables and external antennas) should be
used no closer than 30 cm (12 inches) to
any part of the SERVO-s Ventilator
System including cables specified by the
manufacturer. Otherwise degradation of
this equipment could result.
SERVO-s VENTILATOR SYSTEM V8.0, User's Manual
9
| Introduction |
1 |
To Next Page
Loading...
Need help?
General
