Gilera Fuoco 500 - Removing the Cylinder Head

- Remove pins and rocking levers by the transmis-
sion side holes.
Removing the cylinder head
- Remove the spark plugs.
- Remove the cooling system outlet sleeve with
thermostat.
- Remove the coolant temperature sensor.
N.B.
THE SENSOR CONTROLS BOTH INJECTION
AND THE ANALOGUE INSTRUMENT ON THE
PANEL. TO CHECK THIS COMPONENT, SEE
THE INJECTION CHAPTER.
- Remove the 2 fastening nuts on the head, on the
exhaust and on the intake side.
Engine Fuoco 500 i.e.
ENG - 52