Recommended products
AGIP PERMANENT SPEZIAL Coolant
Monoethylene glycol based antifreeze solution,
CUNA NC 956-16
Braking system
Level check
The front and rear brake fluid reservoirs are both
positioned on the handlebars. Proceed as follows:
- Rest the vehicle on its centre stand with the han-
dlebars perfectly horizontal;
- Check the fluid level through the sight glass
«C». A certain lowering of the level is caused by
wear on the pads.
Top-up
Proceed as follows: Loosen the two fixing screws
and remove the reservoir cover; top-up with the
recommended fluid only without exceeding the
'MAX' mark.
This procedure applies to the rear brake pump top-
up operation; follow the same procedure for the
front brake pump.
Under standard climatic conditions, replace cool-
ant as indicated in the scheduled maintenance
table.
WARNING
ONLY USE DOT 4 CLASS BRAKE FLUIDS.
COOLING SYSTEM FLUIDS ARE HIGHLY COR-
ROSIVE. MAKE SURE THAT IT DOES NOT
COME INTO CONTACT WITH THE PAINT-
WORK.
CAUTION
MAKE SURE THE BRAKE FLUID DOES NOT
GET INTO YOUR EYES OR ON YOUR SKIN OR
CLOTHES. IF THIS HAPPENS ACCIDENTALLY,
WASH WITH WATER.
Fuoco 500 i.e. Maintenance
MAIN - 13
To Next Page
Loading...
