Gilera Fuoco 500 - License Plate Holder; Helmet Bay

License plate holder
- Undo the two upper screws fixing it to the rear
plastic element and the three screws fixing it to the
frame.
Helmet bay
- Remove the side fairings.
- Remove the side handgrips.
- Remove the central frame cover.
- Undo the two screws on the battery compart-
ment, detach the fuse terminal block, the battery
wires and the connector to the diagnostics socket.
- Disconnect the connectors of the power socket
and the helmet compartment light.
- Undo the screws fixing the helmet compartment
light switch to the compartment and disconnect the
electrical terminals.
Fuoco 500 i.e. Chassis
CHAS - 11