Standard Sub-panel RS485
If more than one Sub-panel is mounted within a single enclosure, only one RS485 INTERFACE BOARD or FIBRE-OPTIC
INTERFACE BOARD needs to be used. The Standard Sub-panels will be interconnected via a TTL bus using a cable
form in a daisy-chain from CN4 in the first Sub-panel to CN3 in the next and on to CN3 on the RS485 INTERFACE
BOARD or CON1 on the FIBRE-OPTIC INTERFACE BOARD.
J-NET-RS485-INT-NEW
J-NET-SP
30
Manufacturers of Fire Detection Equipment
INSTALLATION & COMMISSIONING MANUAL REVISION 4.0 05/2013
JUNO NET - NETWORKABLE ADRESSABLE PANEL
globalfire.pt
To Next Page
Loading...
