Global Fire JUNO NET - Power Failure Test

Power Failure Test
Carry out this test to check that the battery system works correctly when mains power fails.
FIRE
FAULT
PRE-ALARM
TEST
DISABLED
SYSTEM ON
ALARM FAULT
SUPPLY FAULT
SYSTEM FAULT
TRANS. FAULT
PAPER FEED
LAMP TEST
SYSTEM RESET
INTERNAL BUZZER
SILENCE
DISABLED
TEST
FAULT
AUXILIARY
RELAYS
SOUNDERS
ENABLE/DISABLE
SELECTED
DETECTORS
DELAYS
ACTIVE
STATUS
FAULTS CONTROLS DISABLEMENTS
QUEUE REVIEW
SILENCE/RESOUND
ALARMS
MANUFACTURED IN THE E.U.
FIRE
-2 AND EN54-4
CERTIFIED
1328-CPD-0160
EN54
FIRE ALARM SYSTEM
Switch off the mains supply to the
panel. After a short delay, the
SUPPLY FAULT LED illuminates
amber and the LCD displays the
message "Primary Supply Fault".
The fault buzzer sounds.
Switch the mains supply back on
and press the SYSTEM RESET
switch. The SUPPLY FAULT LED
extinguishes, the fault message is
removed from the LCD, and the
buzzer stops sounding.
69
Manufacturers of Fire Detection Equipment
INSTALLATION & COMMISSIONING MANUAL REVISION 4.0 05/2013
JUNO NET - NETWORKABLE ADRESSABLE PANEL
globalfire.pt