8-4-4
8-4-5
8-4-6
8-4-7
8-4-8
Set User Access Code
Use this function to set the User Access Code. This access code only permits access to the functions defined by 8-4-5 Set
User Functions.
The code consists of 5 digits.
Don’t forget to tell the user the new number!
Set User Functions
Allows the user access level to be set for every programming function.
Settings are:
NONE
READ ONLY
FULL ACCESS
Do not set 8-4-5 Set User Functions to FULL ACCESS or the user will be able to enable all the other functions!
It is not appropriate to set some functions to READ ONLY - for example “8-3-4 Calculate Program Flash Checksum“.
The default setting for all programming functions is NONE.
Select language
Allows the language setting to for the system to be set.
Do this carefully - you will need to navigate back to this function to change it back again.
All text in the system will be changed to use the selected language. The change will take effect when ENTER is pressed.
Languages supported are:
BRAZILIAN
ENGLISH
FRENCH
HUNGARIAN
ICELANDIC
ITALIAN
PORTUGUESE
SPANISH
Set Installer Access Code
This function allows changing the Installer Code without requiring knowledge of the Factory Code.
Display will show:
Removed (no longer available)
ENTER PRESENT CODE
ENTER NEW CODE
CONFIRM NEW CODE
99
Manufacturers of Fire Detection Equipment
INSTALLATION & COMMISSIONING MANUAL REVISION 4.0 05/2013
JUNO NET - NETWORKABLE ADRESSABLE PANEL
globalfire.pt
To Next Page
Loading...