2
2-1
2-2
2-3
Text Descriptions & Names
All the functions associated with textual labels or names.
Enter Device Text
First select the device then input the text label for that specific device. If the IR keypad is being used, to enter letters
rather than numbers press the SHIFT key momentarily.
If the device already has a text label it will be displayed and can be edited if required.
Each device can have a label of up to 22 characters.
Clears the text to the right of the cursor
Gets the text for the previous device
HOME takes you back to the start of the text
DELETE (PS2 Keyboard only) deletes the character under the cursor
The device text is displayed in the event of a fault, fire or pre-alarm. The text is also shown when the event log is
reviewed or printed.
Enter Zone Text
First select the Zone then input the text label for that Zone. If the IR keypad is being used, to enter letters rather than
numbers press the SHIFT key momentarily.
If the Zone already has a text label it will be displayed and can be edited if required.
Each Zone can have a label of up to 16 characters.
The Zone text is displayed in the event of a fault, fire or pre-alarm. The text is also shown when the event log is reviewed
or printed.
Enter Company Name
Allows the company or building name to be entered.
The name can be up to 28 characters long and will be automatically centered when it is displayed.
The company name is displayed above the date and time whilst the system is not in an alarm or fault state.
The company name also forms the header on the printout after a SYSTEM RESET.
76
Manufacturers of Fire Detection Equipment
INSTALLATION & COMMISSIONING MANUAL REVISION 4.0 05/2013
JUNO NET - NETWORKABLE ADRESSABLE PANEL
globalfire.pt
To Next Page
Loading...