SAFE/PANIC CALL
Safe Monitoring Features
SAFE monitoring feature on WP820 will monitor the user’s safety situation and trigger an alarm once it
detects any unsafe situation. Once the phone detects that the user may be in a dangerous situation such
as unable to move, fall, or being chased using “Safe Monitoring Feature”, the WP820 can quickly alert or
initiate an emergency call for timely assistance.
In particular, the phone will automatically prompt a warning alert and message once it detects any unsafe
situation. If the user does not cancel the prompt warning message to confirm its safety within the set time,
an alarm will be triggered and an emergency call will be initialed (if configured) for assistance.
There are three major types of safety detection methods that can be set on SAFE monitoring settings:
• No movement detection: It detects when the user may be unable to move because of an injury
or a coma, etc. Users can configure the duration of the no movement. If it stays no movement
longer than the duration, the device will be triggered for detection.
• Tilt detection: It detects when the user may be in a state of slipping or falling, etc. Users can
configure the sensitivity and timeout for this detection. With higher sensitivity level on tilt status, a
relative slight falling action will trigger tilt detection and alert.
• Running detection: It detects when user may be in a status of being chased or escaping from a
dangerous environment. Users can configure the sensitivity and timeout for this detection. With
higher sensitivity level on running status, a slower running speed will trigger the running detection.
Users could configure the following SAFE monitoring options under WP820 LCD → Menu → Settings →
Advanced settings → SAFE/Panic Call → SAFE Monitoring Settings:
To Next Page
Loading...
Need help?
General
