GW Instek GDS-2000 Series - Page 153

REMOTE CONTROL CONFIG
153
Configure GPIB interface (optional)
GPIB module
installation
The optional GPIB module is available as a
separate kit. Follow the instruction to install the
module properly.
1. Turn Off the GDS-2000 power
switch.
2. Take off two screws and remove the rear panel
GPIB module cover.
3. Insert the GPIB module and put the screws
back.
4. Turn On the GDS-2000
power switch.
Configure GPIB
1. Press the Utility key.
Utility
2. Press F2 (Interface Menu).
Interface
Menu
F 2
3. Press F1 (Type) repeatedly
to select GPIB.
Type
GPIB
F 1