H3C S7500E Series Installation Manual

85
To do… Use the command… Remarks
Reboot the switch or a card other
than the standby SRPU at once (in
standalone mode)
reboot [ slot slot-number ]
Available in user view.
If no slot is specified, the command
reboots the entire switch.
Reboot the standby SRPU (in
standalone mode)
slave restart Available in system view.
Reboot the IRF virtual device, a
member switch, or a card (in IRF
mode)
reboot [ chassis chassis-number
[ slot slot-number ] ]
Available in user view.
• If neither chassis nor slot is
specified, the command
reboots all member switches.
• If only a chassis is specified, the
command reboots the specified
member switch.
• If you specify both a chassis
and a slot, the command
reboots the specified card in
the specified switch.
Use one of the following commands to schedule a reboot of the switch:
To do… Use the command… Remarks
Schedule a reboot of the switch at
a specific date and time
schedule reboot at hh:mm [ date ]
By default, no reboot schedules are
set.
Available in user view.
Schedule a reboot of the switch
after a specific amount of time
schedule reboot delay { hh:mm |
mm }
By default, no reboot schedules are
set.
Available in user view.
NOTE:
• To reboot the switch or the active SRPU by using the reboot
command, you must ensure that you have
specified a main boot file.
• The switch prompts “REBOOT IN ONE MINUTE” one minute before the rebootin
g
time and then reboots
in one minute.
• For data security, the switch does not run a scheduled reboot task if you are performin
g
a file operation
at the scheduled reboot time.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English