5 - Operation
132
Standard Cleaning
μ
ATTENTION! For cleaning between spray jobs, where crops are not very sensitive towards chemicals just sprayed.
1. Engage the pump with engine in idle, so that pump speed is as low as possible (approx. 250/550 rpm, depending on
pump type).
2. Turn the suction valve towards and the pressure valve towards while transferring approximately 1/ of the
Rinse Tank content into the main tank.
It is important to have full agitation for approximately 20 seconds; and then close the agitation valve completely.
3. Turn the suction valve towards and the pressure valve towards with all boom sections OFF for approximately
45 seconds.
4. Switch all boom sections ON. Spray until air comes out of nozzles. When the pressure drops, close the regulation valve
by pressing the button, until yellow LED lights on the valve. When the boom is completely empty, press the
button for a few seconds to avoid a pressure spike
Repeat the Following Three Steps 5 Times:
5. Turn the suction valve towards and the pressure valve towards while transferring approximately 1/6 of the
RinseTank content into the main tank.
6. Turn the suction valve towards and the pressure valve towards with all sections off for approximately 45
seconds.
7. Turn all sections on. Spray until air comes out of nozzles. When the pressure drops, close the regulation valve by
pressing the button, until yellow LED lights on the valve. When the boom is completely empty, press the button
for a few seconds to avoid a pressure spike close the main ON/OFF valve.
To Next Page
Loading...
Need help?
General
