How to use
1. Touch the 【Reversing Assist】 button on the AVM interface to enable the reverse as-
sist function.
Automatic reversing is completed by following the prompts displayed on the multime-
dia display screen when the reversing assist function is enabled.
Caution
In order to ensure the parking safety, the driver needs to monitor the surrounding environ-
ment of the vehicle at any time, to brake and take over the vehicle in time when there is a
collision risk.
Precautions
When the following situations occur, the system will stop and the recorded route
will be cleared:
〉
The vehicle speed exceeds 30 km/h.
〉
The engine shuts down abnormally.
〉
The turning angle of the steering wheel is too large (about 450°).
〉
The automatic reversing deviates from the recorded route by about 1m.
During reversing, the following conditions will cause the reversing assist function
to be interrupted or exited:
〉
Touch the reversing assist button.
〉
Intervene in gear, steering wheel, parking brake, and accelerator.
〉
Unfasten the driver's seat belt.
〉
Open the door (including the back door).
〉
Fold the rearview mirror.
〉
The system detects that the vehicle cannot continue driving.
〉
Obstacles are detected on the driving track.
Notice
After interruption and exiting due to non-system failure, turn on the reversing assist func-
tion again, and the system can control the vehicle to complete reversing along the re-
maining path.
118
2
Driving
To Next Page
Loading...
Need help?
General
