Vehicle equipment
Please note that this manual contains all
the standard equipment, country-specific
equipment and special equipment for this
model series. Thus, some equipment or
features described in this manual may not
be installed onto your vehicle or are only
available in some markets. For the further
configuration information, please refer to
relevant sales information or consult with
your distributor selling the vehicle to you.
System introduction
While going downhill, the hill descent con-
trol system (HDC) may actively brake to
ensure that the driver can maintain a con-
stant speed and drive downhill safely.
Warning
〉
HDC is intended only to be an aid. At all
times the driver should be responsible
for the safety of the vehicle, and always
pay attention to the surrounding traffic.
〉
In case of too high slope, the HDC may
not function and thus the vehicle can't be
driven down the slope at even speed. At
this time, you can control the vehicle
speed by stepping on the brake pedal.
How to use
0AAE711A7C0A
When the ignition switch is in ON mode or
the vehicle is started, press the button to
enable or disable HDC.
〉
After HDC is turned on, the HDC indica-
tor on the combination instrument
turns on.
〉
After HDC is turned off, the HDC indica-
tor on the combination instrument
goes off.
〉
When HDC is working, the HDC indica-
tor on the combination instrument
flashes.
Notice
〉
It is recommended that HDC should be
used in lower gear.
〉
HDC will be automatically turned off
when the vehicle speed is greater than
60 km/h.
〉
It is still possible to control the vehicle
speed of the vehicle after HDC has been
activated by stepping on the brake pedal
or accelerator pedal.
Hill descent control system
142
2
Driving
To Next Page
Loading...
Need help?
General
