HAVAL H6 2021 - Delay Function; Speedy Closing; Automatic Sunroof Closing; Initialization

Delay function
Within a few seconds after turning the igni-
tion switch to LOCK mode, the sunroof
and sunshade still can be operated.
Speedy closing
With the ignition switch in LOCK mode and
all the doors and back door closed, press
and hold the lock button on the key or the
lock sensor on the door handle to auto-
matically close the sunroof.
Automatic sunroof closing
〉
With the ignition switch in LOCK mode, if
the rainfall and light sensor perceives
rain and snow, the sunroof will be closed
automatically.
Notice
In case of the little rain, the sunroof may
not be closed automatically. It must be
confirmed that the sunroof is completely
closed before leaving.
〉
The sunroof will close automatically if
the vehicle speed exceeds 120 km/h in
the driving.
Initialization
If the system is in disorder, it can be recov-
ered through the following operations:
1. Close the sunroof and sunshade com-
pletely, press and hold the sunroof but-
ton until the sunroof and the sunshade
jitter and then release the button.
2. Press and hold the sunroof button
again within 5 seconds until the sunroof
and sunshade complete the movement
from being open to full closed, then re-
lease the button, and the initialization is
complete.
If the sunroof rebounds during the closing
process, it can be forced to initialize
through the following operations:
1. When the sunroof rebounds, press and
hold the sunroof button immediately,
and continue to keep pressing and
holding the sunroof button after the re-
bound is over, until the sunroof is com-
pletely closed and jitters once, and
then release the button.
2. Press and hold the sunroof button
again within 5 seconds until the sunroof
completes the movement from being
open to fully closed, then release the
button, and the sunroof initialization is
completed.
If the sunshade rebounds during the clos-
ing process, it can be forced to initialize
through the following operations:
1. First close the sunroof completely.
2. Then close the sunshade, and if it re-
bounds, immediately press and hold
the sunshade button. After the re-
bound, continue to keep pressing and
holding the sunshade button until the
sunshade is completely closed and jit-
ters once, and then release the button.
3. Press and hold the sunshade button
again within 5 seconds until the sun-
shade completes the movement from
being open to fully closed, then release
32
1
Operation