Vehicle equipment
Please note that this manual contains all
the standard equipment, country-specific
equipment and special equipment for this
model series. Thus, some equipment or
features described in this manual may not
be installed onto your vehicle or are only
available in some markets. For the further
configuration information, please refer to
relevant sales information or consult with
your distributor selling the vehicle to you.
Locking and unlocking
through the PEPS
When you carry the intelligent key with
you, you can use the passive entry and
passive start system (PEPS) to lock and
unlock the vehicle door.
7CE91F871EC6
Ⓐ Lock sensor
Ⓑ Unlock sensor
Unlocking
Touch the unlock sensor to unlock all the
doors and back door. In this case, the turn
signal lamp will flash twice.
Notice
Unlock mode can be set via 【vehicle set-
ting】 → 【body】→【door 】 interface
on the multimedia display screen.
If the unlock mode is set to 【driver un-
lock】, when the driver's door unlock sen-
sor is touched, only the driver's door and
the back door are unlocked. At this time, if
you touch the unlock sensor again, all
doors will be unlocked.
Locking
Touch the lock sensor to lock all the doors
and back door. In this case, the turn signal
lamp will flash once.
Notice
When the door is locked, if the turn signal
lamps do not flash, check whether all the
doors, the back door and the engine hood
are closed fully.
Notice
〉
Only the doors with intelligent key detec-
ted can be operated.
〉
Please do not lock and unlock the door
at the same time.
〉
If you wear gloves to operate the door
handle, you may not be able to unlock or
lock the door.
〉
The radio waves of the PEPS is a little
weak. When surrounded by other radio
equipment or blocked by other barriers,
Door lock
19
1
Operation
To Next Page
Loading...
Need help?
General
