function will be triggered, and the driver
must confirm that the vehicle windows are
completely closed before leaving.
Initialization
When errors occur in one-push raising or
lowering function, you can reset it through
the following operations:
1. Change the ignition switch to ON
mode.
2. Pull up the window switches equipped
with one-push raising or lowering func-
tion beyond the pressure point until the
window is completely closed and then
hold for about 3 seconds.
3. Operate the window switch again so
that the window goes through the one-
push raising and one-push lowering.
Notice
When the one-push raising or lowering
function is disordered or every time the
battery is disconnected and re-energized,
the windows with one-push function need
to be initialized.
29
1
Operation
To Next Page
Loading...
