be mixed and burned in combustion
chamber, causing decrease in oil
amount as the vehicle travels. Engine oil
levels may go down depending on your
specific drive conditions.
〉
Take care not to exceed marked maxi-
mum levels when topping up engine oil.
Brake fluid
Checks
The fluid level in the tank should be
checked regularly.
Check that the fluid level in the tank is be-
tween the minimum and maximum marked
levels.
If the brake fluid level is lower than the
minimum level marked, top up with new
brake fluid until the level is between the
maximum and minimum levels marked. Al-
so make sure that the braking system
shows no signs of leakage.
Filling
1. Pull the two pawls of the cover plate as
shown in the figure to remove the cover
plate.
C3CC71985C25
2. Remove the cover plate, and the brake
fluid tank can be seen.
68A417EC7FC2
3. Pry open the tank cover. Pour in the
fluid slowly to prevent overflow. Any oil
overflow must be removed immediate-
ly. Otherwise, the spilled oil may cause
damage to the compartment compo-
nents.
Please only use brake fluid that meets
specifications.
4. After filling, install and reset the liquid
storage tank cover and cover plate.
Warning
〉
Insufficient brake fluid levels can com-
promise brake performance and in-
crease the risk of an accident.
〉
Brake fluid is harmful to the human body
and corrosive. In case of accidental con-
tact, rinse immediately with plenty of wa-
ter. If you ingest it, go to a hospital im-
mediately.
Engine/drive motor coolant
Checks
The water level in the overflow tank should
230
6
Maintenance
To Next Page
Loading...
Need help?
General
