the windshield.
5. Install a new wiper blade and return the
wiper back to the windshield.
To facilitate installation, please refer to
step 3 to maximize the included angle
between the wiper blade and the plas-
tic connector.
After installation, please move the wip-
er up and down to ensure that it is in-
stalled in place.
6. Reset the wiper to the initial state.
The wiper automatically resets to the
initial state when the ignition switch is
switched to the ON mode or the vehicle
is started.
Replace rear wiper blade
1. Lift the wiper arm from the windshield.
Caution
The rear wiper arm has a limited lift angle
of about 45 °. Do not over lift or use exces-
sive force when lifting up, otherwise there
is a risk of damage.
2. Pull the wiper blade in the direction
shown until the blade is free of the wip-
er arm.
67255DED83DC
Caution
When the wiper blade is not installed, nev-
er place the wiper arm directly on the
windshield as it is capable of scratching
the windshield.
3. Install a new wiper blade and return the
wiper back to the windshield.
Bulbs
The front combination lamps on a new ve-
hicle have been calibrated at the factory. If
you often carry heavy items in the vehicle,
the front combination lamps may need to
be re-calibrated. The calibration of the
front combination lamps should be done at
a service provider.
Replacing bulbs
All exterior lamps are LED lamps and can-
not be disassembled separately or re-
placed individually. In case of bulb damage
or malfunction, it is recommended that you
go to service provider for inspection and
repair as soon as possible.
236
6
Maintenance
To Next Page
Loading...
